Correct operation using crawler tractors traveling

When the bulldozer steering, brake pedal should be smooth to avoid beating occurred when cornering. After turning the brake pedal should be loose, and then release the joystick. If the turning radius is large, you do not step on the brake pedal. No heart to avoid making situ rotation speed bulldozers,Mechanical Crawler bulldozer derailment caused the accident.
3, driving on the ramp
Different models have different climbing ability swamp hydraulic crawler dozer (typically 30 °), the same structure can adapt bulldozer slope and terrain are not the same. The driver should be familiar with the type of climbing limit, avoid the cause, lack of capacity and downhill landslide phenomenon.
Before the uphill, should be based on topography, slope size and length, select the appropriate speed gear, climbing halfway shift allowed. Uphill, bulldozers should run hillside transverse vertical angle was not allowed to travel on steep slopes laterally; lower blade may be appropriate, so as not to affect the eye, and in the event of landslides can quickly make the blade of the bulldozer to help brake; uphill on the way in case they turn off the engine, should immediately stop the oil, put down the shovel and the emergency brake. When the slope can not be shut down, should be replaced by reverse slowly slide into the base (side brake side slip), and then start to persuade; if not stop the oil, and slid forward Dangdang bit, due to the anti-spread power engine fire caused by reversed, causing the air filter out fuel injection. In case of reversal of fire, they should quickly close the throttle, brake and bulldozers to live. Before restarting, check the shift lever is in the neutral position.
When the bulldozers downhill, should use low gear small throttle position, and use the brake pedal.